7037ma - 7037 lithium grease - united states 2008-8-14.pmd

PRODUCT: Crown Lithium Grease
aterial Safety Data Sheet
SECTION III - PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING POINT: N/A
SPECIFIC GRAVITY (H20=1, @70°F): 0.66
VAPOR DENSITY: Heavier than air
SOLUBILITY IN WATER: Negligible
EVAPORATION RATE: Slower than Ether
APPEARANCE AND ODOR: Tan / Hydrocarbon Odor
TO: MSDS USERSPlease find below the material safety data sheet as per your request.
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
The information presented in these forms is believed to be correct and sufficient to meet the requirements of OSHA Hazard Communication FLASH POINT: < 0° F (-18° C)
METHOD USED: Estimated
FLAMMABLE LIMITS - LEL: 1.2% UEL: 9.5%
standard (29 CFR 1910.1200) concerning worker's right to know. In order for the information contained in the MSDS to be most helpful EXTINGUISHING MEDIA: Carbon dioxide, foam, dry chemical.
we recommend that these forms be made available to all those who handle or may otherwise be exposed to the product.
SPECIAL FIRE FIGHTING PROCEDURES: Water spray may be used to cool containers exposed to heat or fire to prevent pressure build up. Self-
This MSDS covers the following Aervoe aerosol product.
contained breathing apparatus should be used if product is involved in fire.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Treat as cylinders of compressed gas. Closed containers may rupture due to pressure build up from
PRODUCT NAME:
HMIS CODES: H F R P
SECTION V - REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID: Open flames, sparks, electrical arcs.
INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizing agents, strong acids or bases.
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: Carbon Monoxide and Carbon Dioxide
HAZARDOUS POLYMERIZATION: Will not occur
SECTION VI - HEALTH HAZARD DATA
INHALATION: Respiratory tract irritant. May cause dizziness, light-headedness and / or headaches.
SKIN CONTACT: Prolonged or repeated contact may cause defatting and / or dermatitis.
EYE CONTACT: Painful and slight to moderate irritation.
SECTION I - MANUFACTURER IDENTIFICATION
SKIN ABSORPTION: Very low toxicity.
MANUFACTURER'S NAME: Aervoe Industries Inc.
ADDRESS: 1198 Mark Circle, Gardnerville, NV 89410
INGESTION: May cause chemical pneumonia if aspirated into the lungs.
CARCINOGENICITY: None known
IARC MONOGRAPHS: No
OSHA REGULATED: No
INFORMATION PHONE: 775-782-0100
EMERGENCY PHONE: 1-800-424-9300
TERATOGENICITY: Not established
MUTAGENICITY: Not established
DATE REVISED: August 14, 2008
REASON REVISED: Updated
MEDICAL CONDITION GENERALLY AGGRAVATED BY EXPOSURE: Not established
EMERGENCY AND FIRST AID PROCEDURES: INHALATION - Remove from exposure. Seek medical attention if signs/symptoms persist.
SPLASH - (SKIN) Wash affected area with soap & water, remove contaminated clothing, seek medical attention if irritation persists.
SPLASH - (EYES) Flush immediately with water for 15 minutes and see medical attention if irritation persists.
INGESTION - Do NOT induce vomiting. Drink plenty of water.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
SECTION II - HAZARDOUS INGREDIENTS / SARA III INFORMATION
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Remove all sources of ignition: Flames, sparks, static electricity &
OCCUPATIONAL EXPOSURE LIMITS
electrical. Ventilate area, avoid run off into sewer by diking, and soak up with inert absorbent using non-sparking type tools.
WASTE DISPOSAL METHOD: Dispose of in accordance with local, state and federal regulations. Do not incinerate closed containers.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Do not store above 120° F (49° C). Do not store or use near heat, sparks or flame.
OTHER PRECAUTIONS: Do not get in eyes. Do not breathe vapors. Avoid skin contact. Do not take internally. Smoking while using this product
SECTION VIII - CONTROL MEASURES
RESPIRATORY PROTECTION: Respiratory protection program should be in accordance with 29 CFR 1910.134.
VENTILATION: All application areas should be adequately ventilated in order to keep the items in SECTION II below their exposure limits.
PROTECTIVE GLOVES: Polyethylene or Neoprene gloves are recommended.
EYE PROTECTION: Safety glasses with side shields are recommended.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Not established.
WORK / HYGIENIC PRACTICES: Avoid prolonged or repeated contact. Do not breathe vapors. Wash contaminated clothing prior to reuse.
SECTION IX - DISCLAIMER
THE INFORMATION CONTAINED HEREIN IS BELIEVED TO BE ACCURATE BUT IS NOT WARRANTED TO BE SO. NOTHING CONTAINED ***No toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372 are present.*** HEREIN CONSTITUTES A SPECIFICATION NOR IS IT INTENDED TO WARRANT SUITABILITY FOR THE INTENDED USE.
NOTE: N/A applies to not available or not applicable

Source: http://sumotec.com.my/document/Lithium%20Grease%207037%20-%20US.pdf